Highsider AKRON-RS license plate holder for Honda CB 300 R 18-, ohne KennzeichenbeleuchtungThe Highsider AKRON-RS license plate holder adapts perfectly to the lines of your bike through its design.The model-specific bracket of the Highsider AKRON-RS allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.The license plate is made of sheet steel and 2 mm thick. The precise cutting is done by laser. After edging still follows the weather-resistant black powder coating.This ensures the optimal fit and durability.Through the stepless adjustment you can bring the plate without drilling in the desired position. To keep the plate in this position, there is an additional locking screw.The turn signal brackets of the Highsider AKRON-RS are adjustable in width and thus suitable for any type of accessory turn signals. This adjustment option allows you to adjust the position for your turn signals to the most diverse license plates. To allow mounting of the turn signals without separation from the wiring harness, the 8 mm holes are slotted to the side.Also the position of the reflector you can adjust individually via a slider. Adaptation to the different designs of EU license plates is therefore no problem.To screw the license plate securely and reduce vibration are included two rubber washers. Another rubber buffer supports the license plate on its underside.Details:model-related bracketinfinitely adjustable turn signal holderslotted turn signal holder for easy mounting without cable separationinfinitely adjustable reflector, E-approvedsuitable for European license platesinfinitely adjustable tilt angleadditional screw for optimum position securityeasy fixation without further work steps (eg. Drilling)easy mounting of the license plate through slotted holesIncluded in the scope of delivery of the Highsider AKRON-RS are:Model-related bracket with mounting partsHighsider AKRON-RS license plate mounting plateAdjustable turn signal bracketsE-tested reflector with adjustable holderMounting instructionsNotes:If side reflectors are mounted on your original license plate holder, they must be reattached in a suitable position or replaced with new ones.Special turn signal holders are optionally available for the original turn signals.Tip:Should you have found no model-specific license plate holder for your vehicle, the universal license plate holders from Highsider, which are available in many different designs, are certainly a good alternative. 8260 1175 288 273 105 Black Steel
Highsider License Plate Holder Akron-RS 280-616H - Köp!